Rena Envelope Imager 3.0 - Manual (Page 11)

SECTION 1
GETTING ACQUAINTED
Print Carriage View
19
18
20
21
22
23
24
Figure 8
25
18.
MEDIA TRANSPORT GUIDE / ENVELOPE IMAGER 4.0 PRINT UNIT
Envelope Imager 4.0: An additional Print Unit will be mounted here.
Envelope Imager 3.0 device can be positioned to improve material transport.
19. PRINT UNIT SECURING KNOBS – Used to secure the print unit positions.
20. MEDIA SENSOR – Keep this area clean (see Section 4 “Maintenance”).
21.
INK CARTRIDGE LATCH LEVERS – Used to secure the inkjet cartridge in to the
Pen Stall.
22. PEN STALL – The area where the inkjet cartridge is inserted.
23.
PRINT UNITS –Hold the inkjet cartridges. Used to adjust the vertical print position.
The Envelope Imager 3.0 (shown above) contains 2 Print Units, each capable of holding 3 ink
cartridges. (6 ink cartridges, for a total of 3” print height)
The Envelope Imager 4.0 contains 4 Print Units; two are capable of holding 3 ink cartridges each
and two are capable of holding 1 ink cartridge each. (8 ink cartridges, for a total of 4” print height)
24.
EXIT ROLLERS – These adjustable rollers help to smoothly eject the media from the
unit.
25. MEDIA TRANSPORT BELTS – Drives the material through the system.
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007
11