Rena Envelope Imager 3.0 - Manual (Page 53)

SECTION 5
TROUBLESHOOTING
Head # Low: Press Enter
Printer’s ink level monitor has
calculated that cartridge # is
almost empty.
(# = cartridge position number)
If empty, replace cartridge and
reset ink level monitor.
If not empty, you may ignore
message and or reset the ink
level monitor.
Out of Memory Font
No enough memory for
downloading a font
Reduce the number of different
fonts you are trying to use from
your software.
Out of Memory Char
No enough memory for
downloading a single character
Reduce the number of
characters you are trying to use
from your software.
Error in Download Font
Encountered a wrong font
Format
Only font-format 0 supported.
Clear job and try again. If
problem persists, contact
software vendor and or test from
a different software program.
Error in Download Char
Encountered a wrong character
Format or Class.
Only character format 4
(LaserJet Family - Raster), Class
one and two are supported.
Clear job and try again. If
problem persists, contact
software vendor and or test from
a different software program.
Error in ESC Sequence
The Escape command is
formatted incorrectly.
Try again. If problem persists,
report problem to software
vendor.
Ignore Unknown ESC Comnd
The Escape command sent is not
supported.
Try again. If problem persists,
report problem to software
vendor.
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007
53