Rena TB-690 - Manual (Page 4)

2
This conveyor can be used for Right Angle or Straight Through operation. In addition it can be
run in the Left-to-Right or Right-to-Left operating mode.
Setting up the Conveyor
1. First determine if the conveyor is to be used in the
Left-to-Right or Right-to-Left mode. A switch is
mounted under the conveyor near the front left-
hand side of the conveyor on the motor mounting
plate.
CAUTION
DO NOT SWITCH DIRECTION OF
BELTS WHEN MOTOR IS
RUNNING.
OVERLOAD MAY OCCUR AND
FUSES WILL BLOW AND/OR
BREAKER WILL TRIP.
2. Next mount the stacking tray to the appropriate
end of the conveyor using the three screws
supplied.
NOTE: THE STACKING TRAY CAN BE
MOUNTED TO EITHER END OF THE
CONVEYOR DETERMINED BY THE
DIRECTION THE BELTS TRAVEL.
3. If the conveyor is to be used in the straight
through mode the Right Angle Guide should be
removed. If the Right Angle Guide has to be
moved to the opposite end of the conveyor do the
following:
a) Remove the Right Angle Guide by first
removing the two screws that attach the
mounting bracket to the conveyor.
b) Then slide the guide assembly to the right
and lift it from the conveyor.
Note: The image, shown to the right, was taken
from the operator side of the conveyor. It shows the
Right Angle Guide’s finger and the corresponding
slot in the conveyor body.