Rena TB-690 - Manual (Page 6)

4
4. Feed stock through the machine and onto the conveyor to check operation.
Troubleshooting
If the conveyor should fail to run, check for
jammed paper between the belt and roller.
Also, check the fuse and motor circuit breaker
and replace or reset if necessary. The fuse
holders and circuit breaker are located on the
rear of the conveyor, next to the power inlet.
WARNING
DISCONNECT THE POWER CORD WHEN CHECKING OR REPLACING FUSE!
ALWAYS REPLACE THE FUSE WITH THE SAME TYPE. FAILURE TO DO SO MAY DAMAGE THE
ELECTRONIC CIRCUIT BOARD.