Rena TB-390 - Manual (Page 12)

TB-390 Operations Rev. 7/30/2014 11
6. Remove the two Levers [4] and Bearing
Washers [5] from the two Dryer Support
Shafts [6]. Install the two shaft assemblies
into the holes provided in the Dryer as
shown. Reinstall the two Levers [4] and
Bearding Washers [5] to the shafts.
NOTE: When installing the two Levers [4]
make sure that the cams on the opposite side
of the shaft are in the same position as the
cams on the levers.
The dryer images shown are of an older dryer model.
7. The Dryer Assembly can now be placed in
the support brackets. Make sure that the
Bearing Washers are between the support
brackets and the cams as shown.
Note: Image depicts conveyor being used for
right to left transport.
NOTE: The Bearing Washers should go between the
support brackets and the cams.