Rena TB-390 - Manual (Page 3)

TB-390 Operations Rev. 7/30/2014 2
INTRODUCTION
The TB-390 conveyor is used to transport media away from the exit end of a printer or tabber
and deposit/stack the media into a drop-tray or against an optional back-stop. The stacked media
can then be removed, from the back-stop or drop catch tray, without the need to stop the printer
or tabber.
An optional dryer and dryer mounting kit can also be installed on the TB-390 conveyor to aid in
drying the images applied by an inkjet printer. See the section titled “Optional Accessories”.
SPECIFICATIONS*
Power Requirements
Optional 230V Model
115 VAC, 50/60 Hz, 1.0 AMP
-9.0 AMP with 115V, 700W dryer option
230 VAC, 50/60 Hz, 1.0 AMP
-5.5 AMP with 230V, 700W, dryer option
Motor Circuit Breaker
Fuses:
1 AMP
0.5 AMP x2, 250V, slow blow
- for speed control board.
NOTE: Dryer outlet is NOT fused within
conveyor. Dyer fuses are located on the
optional dryer.
Speed Of Belts: 25 to 250 feet per minute (variable)
-min and max speeds are approximate and can
vary between conveyors.
Dimensions: Width: 15 in. (38.1 cm)
Length: 34.5 in. (87.6 cm)
Height: 5 in. (12.7 cm, from table top)
Weight: 33 pounds (15 kg)
* MANUFACTURER RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT WRITTEN NOTICE.