Research Concepts RC2000C - Manual (Page 72)

64 RC2000C Az/El Tracking Antenna Controller Chapter 6 Specifications
Research Concepts, Inc. • 5420 Martindale Road • Shawnee, Kansas • 66218-9680 • USA www.researchconcepts.com
Chapter 6 SPECIFICATIONS
Inspect unit for any damage sustained during shipping. If any exists, notify shipper immediately.
A. PHYSICAL
Size: 19.0" x 3.5"H x 9.0"D (Rack)
Weight: 12.5 lb.
Temperature: 0-50oC
Input Power: 115/230 VAC, 50/60 Hz., 48 W Non-driving, 600 W driving
B. DRIVE
Output: 12-36VDC, 8.0 Amps
280VA
Sensor Input: Reed, Hall Effect, Optical
Polarization: Standard Polarotortm Interface
24V Rotating Feed with Pot Feedback (RC2KPOL option)
Note: Not all models support polarization control.
C. TRACK MODE
Antenna Size: 0.4 - 12.0 meters
Tracking Accuracy: Mount Dependent
0.1 - 3.0 dB, selectable
Maximum Inclination: +/- 16 deg., standard
Tracking Modes: Intelli-Searchtm, Step Track, Program Track
AGC Input Range: 0-10.0 VDC
AGC Input Impedance: 2M ohm
AGC Inputs:
2
Inclined Satellites: 5 Max
Total Number of Satellites: 35 (Geo + Inclined Orbit).
D. Drive Transfer Function - See Figure in Appendix
E. Non-Volatile Memory Battery - Duracell DL2450
F. The azimuth and elevation axis drive output are protected by a circuit breaker accessible via the
controller’s backpanel. When the drive breaker is open, the breaker’s button will protrude from
the mounting bezel. The controller AC input is protected by a user replaceable fuses (1/4” x 1
¼”) housed in a fuse drawer built into the controller’s IEC type, power entry module. Replace
with 6 amp AGC (fast-blow) fuses. RCI part # F-6A-FB-C, Bussman part # ABC-6, Little Fuse
part # 314006.