Dolby Laboratories Personal Video Recorder - Manual (Page 44)

Page 44 of 46
TO CHANGE THE HARD DISK
ATTENTION: Before you change
the hard disk, you must switch off
and unplug the PVR to avoid any
possible damage to the hard disk
or the circuit.
NOTE: You should prepare a new
hard disk using FDISK to partition
and format it in your PC before
installing it in the PVR.
The format must be FAT32 and
the hard disk set to be in SLAVE
mode.
To remove the hard disk:
1. Open the door to the hard disk.
2. Take out the hard disk using the handle.
3. Slide the cover off the hard disk caddy.
4. Use a screwdriver to take out the four
screws.
5. remove the hard disk after
disconnecting the power and data cables.
After partitioning formatting the
hard disk in a PC insert the new
hard disk into the caddy.
Steps:
1. Connect the two cables to the hard
disk.
2. Slide the caddy cover back on.
3. Replace the retaining screws.
4. Replace the caddy into the PVR and close
the door. Plug the PVR back into the
electrical supply and switch on. If
there is some problem with the
connection re-insert the caddy to re-
make the connections.