Sea Eagle RazorLite Kayaks (393RL RazorLite, 473RL RazorLite) - Manual (Page 10)

DEFLATION DEFLATION
CAUTION! Air comes
out with force.
To deflate, push the
valve stem down and
turn it a quarter turn to
the right. The stem will
stay in the down posi-
tion allowing air to es-
cape.
Fold one wall over the
other. Push the floor
over until the skeg base
is up. Make a fold be-
tween the drains and
the skeg base. This will
keep the skeg base flat.
Keep folding until the
bow is almost reached,
then lift the edge and
fold the bow under.
Slide the narrow end of
the boat into the back-
pack bag. Folding the
473RL requires more
folds than shown here
and there will be less
room in the bag for ac-
cessories.
Backpack Carry Bag
Slide the seat in with
the boat. The paddles
and pump will fit along-
side the boat in the
Backpack bag.
CLEANING & PROTECTING CLEANING & PROTECTING
Dry after each use to avoid mold. While washing or rins-
ing: close the valves and twist the caps on so water
cannot not enter the chambers. Sea Eagles can be
cleaned very effectively with general purpose cleaning
products and a scrub brush.
Water collects under the sides of the floor of the Razor-
Lites. To drain, elevate the front so water runs down and
collects in stern. Turn boat over and lift the back so water
spills out. Towel dry the lowest areas.
Protection from the Sun and Heat
Avoid leaving it in direct sunlight when ashore. Tempera-
tures on a beach, dock, davit, etc., can get very high which
could affect the vinyl or glue. Excessive exposure to sun
and heat can cause your Sea Eagle to become sticky or
cause the glue to fail.
Cleaner & Protectant
UV protectant such as
303 Aerospace Protec-
tant, should be applied
to the vinyl every 3-5
weeks. Protectant pre-
serves the vinyl and
makes it easier to keep
the Sea Eagle clean.
3M Marine Cleaner and
Protector combines
cleaning and sun pro-
tection.
9
RazorLite Kayaks | DEFLATION, CLEANING & PROTECTION DEFLATION, CLEANING & PROTECTION