Sea Eagle 124 smb Super Motormount Boat (124SMB) - Manual (Page 12)

Repair Kit
All Sea Eagles come
standard with a repair
kit which includes two
material patches and
tubes of PVC based
glue.
PVC Based Glue
For repairs on our boats
you will need to use a
PVC based glue. We
suggest this 12 oz. can
of Vyna Bond if you
need more glue than
what comes standard in
the repair kit.
Repair: Pinholes
Deflate your boat and
thoroughly clean and
dry the area that is to be
repaired. For small
punctures less than 1/8”
apply a small drop of
glue and allow 12 hours
to dry.
For immediate use
allow 30 minutes to dry
and then inflate the
compartment with the
repair only 3/4 full and
be sure to make a more
permanent repair later.
Repair: Patching
Leaks that are larger
than a pinhole can be
patched. Most patches
can be done in a few
minutes, but we do offer
a repair service for
more complex jobs out
of warranty.
Once you have located
the leak make sure you
thoroughly clean the
area surrounding the
leak of any dirt or grime.
After the area is clean
and dry you can circle
the area to make locat-
ing the leak easier
throughout the repair
process.
Using a ball point pen,
trace the outline of your
patch which should be
large enough to overlap
the damaged area by
approximately 1/2”.
Angle the pen inward a
bit so that the ink will be
covered by the patch
later.
Ap ply ad he sive to the
dull side of the patch
and around the area to
be repaired. Coat the
affected area lightly but
completely with glue.
11