SIGMA ELECTRONIC FLASH EF-610 DG SUPER SO-ADI (ソニー用) - Manual (Page 22)

21
B. USING THE SIGNAL OF THE FLASH THAT IS ATTACHED TO THE
CAMERA AS THE TRIGGER
For Wireless Flash, two or more EF-610 DG SUPER SO-ADI flash units are necessary. EF-530 DG
SUPER SO-ADI can be used only with off-camera mode. Depending on the flash unit model of
off-camera flash, it is necessary to change the control mode of the controller. Please see the below
chart. (EF-610 DG SUPER SO-ADI can be used for the controller).
Flashgun model can be
used for off-camera flash
EF-610 DG SUPER SO-ADI
EF-530 DG SUPER SO-ADI
EF-610 DG SUPER SO-ADI
Control Mode + -
Camera model can be
used with off-camera flash
α700, α900 α900
Ratio-Flash Control setting
It is possible to control up to 3
groups;Controller, Off-Camera
Flash 1 and Off-Camera Flash 2.
It is possible to set flash-ratio of
each group from 5 levels or
without falsh. It is possible to control 2
groups;Controller and Off-Camera
Flash.
Controller : It is possible to set the
ratio of off-camera flash to 1:2 or
2:1.
Flash Mode
TTL Auto flash, High Speed Sync
Flash (TTL, M), Manual flash TTL Auto flash, High Speed Sync
Flash (TTL)
B-1.In the case of using only off-camera flash
Camera and Controller Setting
1. Set the camera to the wireless flash mode.
◆ Since the settings vary depending on the camera model, please refer to the instruction manual for
your camera.
2. Set the camera’s exposure mode to P,A,S or M.
3. Attach the flashgun to the camera body.
4. The flashgun’s LCD panel will be switched to the controller
setting display automatically. (If the LCD panel will not be
switched automatically, press the
button until the
controller setting display appears.)
5. The control mode display will blink when the button is
pressed.
6. Set the control mode to by pressing the or button.
7. Channel information will blink when the button is pressed.
8. Set the channel number (C1 - C4) by pressing the or button.
9. The ratio-flash control display will blink when the button is pressed.
10. Set the ratio-flash control mode to [ ] by pressing the or button.
11. Press the button again, the display will stop blinking.
Off-Camera Flash Setting
12. Press the button until the off-camera flash display appears.
13. Set the off-camera flash number to 1 by pressing the button.
14. Press the button to set the flash mode to TTL.
15. Channel information will blink when the button is pressed.
16. Press or button to choose the same channel number as
set on the controller.
17. Press the button, the indicator stops blinking.
18. Place the off-camera flash at the desired position.
19. Check that both flashes are fully charged.