SIGMA ELECTRONIC FLASH EF-610 DG SUPER SO-ADI (ソニー用) User Manual
Page 23
22
◆
Ready light lamp will light, and the AF Auxiliary lamp will blink to indicate that the flash is ready for
shooting.
20. Adjust the focus on the subject, and take the picture.
B-2. Ratio-Flash Control (Control Mode )
Camera and Controller setting
1. Process the same setting from step 1 to 9 of B-1.
2. Set the ratio-flash control mode display to the [
] by
pressing the
or
button.
3. The flash mode display will blink when the
button is
pressed.
4. Set the flash mode to TTL by pressing the
or
button.
5. The ratio-flash display [
] of the controller will blink when the
button is pressed.
6. Set the ratio of the controller by pressing the
or
button.
7. The ratio-flash display [
] of Off-Camera Flash 1 will blink when the
button is pressed.
8. Set the ratio of Off-Camera Flash 1 by pressing the
or
button.
9. The ratio-flash display [
] of Off-Camera Flash 2 will blink when the
button is pressed.
10. Set the ratio of Off-Camera Flash 2 by pressing the
or
button.
11. Press the
button, the indicator stops blinking.
Off-Camera Flash Setting
12. Process the same setting of B-1 Off-Camera Flash Setting.
◆
If the off-camera flash unit is plural, allocate the desired off camera flash number to each unit.
◆
It is possible to set the flash ratio for the controller, Off-Camera Flash 1 and Off-Camera Flash 2 as
follows.
(without flash)、1、2、4、8、16
The ratio of flash output amount is setting the value of each unit / total value.
[Example]
Setting value
Ratio of flash amount
Controller 2
2/7
Off-Camera Flash 1
1
1/7
Off-Camera Flash 2
4
4/7
B-3. Ratio-Flash Control (Control Mode )
Camera and Controller setting
1. Process the same setting from step 1 to 6 of B-1.
2. Set the control mode to
by pressing the
or
button.
3.
Channel information will blink when the
button is
pressed.
4. Set the channel number (C1 – C4) by pressing
or
button.
5. Set the ratio-flash control mode display to the [
] by
pressing the
or
button.
6. The ratio-flash display will blink when the
button is pressed.
7. Set the ratio of the controller: Off-Camera Flash by pressing the
or
button.（Select the
or
.）
8. Press the
button, the indicator stops blinking.