Sloan Xlerator HAND DRYER - Manual (Page 3)

SLOAN VALVE COMPANY • 10500 Seymour Avenue • Franklin Park, IL 60131
Phone: 1-800-9-VALVE-9 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380
www.sloanvalve.com
Rev. 1 (06/10) Copyright © 2010 SLOAN VALVE COMPANY
Item # Part # Description
1. — Cover (includes Nameplate)
2. — Nameplate
3. — Tamper-proof Fastener
4. — Tamper-proof Wrench
5. — Air Outlet (includes gasket & fasteners)
6. — Terminal Block (includes fasteners)
7. — Control Assembly & Sensor
TROUBLESHOOTING GUIDE
As with any electrical appliance, repairs to be performed by
qualified service personnel.
I. If dryer does not turn on
A. Verify that the dryer is receiving power by checking electrical service,
circuit breaker or fuse to the dryer. If power is OK,
B. Check voltage to dryer terminal block. If OK,
C. May be mounted too close to a counter or object. (see installation note).
If OK, see option D.
D. Check for loose wires on dryer control and for foreign material on dryer
sensor next to air outlet. If OK,
E. Replace dryer control.
II. If dryer does not shut off
A. May be mounted too close to a counter or object (see installation note).
If OK, see option B.
B. Check for loose, disconnected or improper wiring at dryer control.
If OK, see option C.
C. Replace dryer control.
III. If dryer heats up but no air comes out
A. Check motor fuse if so equipped. If OK, see option B.
B. Replace motor.
IV. If dryer does not always turn on, or turns on by itself
A. May be mounted too close to a counter or object (see installation note).
If OK, see option B.
B. Check for foreign material on optical sensor next to air outlet. If OK, see
option C.
C. Check for loose wires on dryer control. If OK, see option D.
D. Replace dryer control.
V. If dryer blows only cold air
A. Check for loose connections to heating element. If OK, see option B.
B. Replace heating element.
VI. If dryer has a loss of air volume
A. Check for air leaks at the heating element. If leaking, replace heating
element. If OK, see option B.
B. Check for slow running motor or burning smell. If so, replace motor.
If further assistance is required, please contact the Sloan Installation
Engineering Department at: 1-888-SLOAN-14 (1-888-756-2614).
Item # Part # Description
8. –– Heating Element Assembly
9. –– Motor Assembly (includes gaskets & wire harness)
10. — Wall Plate Assembly (includes cover mtg. brackets)
11. — Cover Mounting Brackets
12. — Housing Grommet
13. — Housing Retainer
14. — Optics Assembly (Sensor)
5
6
7
8
4
9
1
2
3
10
14
13 (4)
12 (4)
11 (2)
NOTES: Model, Serial Number and Voltage of this dryer MUST BE included when ordering parts.
For dryers with voltages not shown or part numbers not shown, please contact Sloan Installation Engineering Department at:
1-888-SLOAN-14 (1-888-756-2614).
The information contained in this document is subject to change without notice.
PARTS LIST