Adjustments, Continued) – Smithco Super Star X-Treme Gas 43-000-x (sn 43375 – Current) Parts & Service Manual User Manual
Page 12
10
Service
ADJUSTMENTS
(CONTINUED)
WHEEL ‘CREEP’ ADJUSTMENT
‘Creep’ is when engine is running and hydrostatic transmission
is in neutral, but due to inadequate alignment, wheels still
move. Do the following procedures to stop this motion.
1. Lift up and support machine so all wheels are off the
ground and can turn freely.
2. On the top of the pump there is a ball bearing on a creep
arm. Loosen the bolt (A).
3. With engine running adjust the ball bearing right or left in
slot so ball bearing centers on the swash arm.
4. Tighten all fasteners and test by using foot pedal linkage
to see that the "creep" is removed.
5. Turn engine off and lower machine.
PARK BRAKE
The park brake is located on the right hand side of the machine and operates a brake
on the right rear wheel. Push lever forward to engage and pull back to disengage.
To adjust turn the knob on the end of the handle. For further adjustment you may turn
the yokes (A) clockwise to tighten and counter clockwise to loosen.