Smithco Super Star X-Treme Gas 43-000-x (sn 43375 – Current) Parts & Service Manual - Manual (Page 151)

C-47
Rear Attachment
42-585 GREEN STAR RBS BRUSH SET (3) PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 42-539 Lynch Pin 5 /
16
(part of main frame) 4
2 18-295 Oilite Bushing (part of 42-579) 6
3 HSPP-516-18-075 Phillip Head Screw 5 /
16
- 18 x 3 /
4
6
4 42-579 Brush Bracket 3
5 42-545 Brush Head 3
6 42-586Q Green Star RBS Main Frame 1
ADJUSTMENTS AND OPERATION INSTRUCTIONS
ADJUSTMENT
The springs are preset for maximum down pressure, and should not need to be adjusted. If you feel the need to
adjust the springs please call for further instructions. The unit comes pre-adjusted for most models.The four
adjustment holes on the hitch are for making sure all three brushes are touching the ground at the same pres-
sure. When installing brush system start with the lower mounting holes on hitch.
Tire pressure should be 4 psi in the front and 7 psi in the rear tire for best traction.
OPERATION
Make sure the brush system has been installed and adjusted properly for your model of bunker rake. Always
transport in fully raised position. Always remove flag pole before brushing green. Do not stop on green while
brushing. Do not brush up steep slopes or loss of traction may result. Do not turn while brushing.
For drag brushes use hydraulics to control the amount of down pressure required to move your top dressing
material. We recommend reversing drag brushes after each use for even wear. To begin brushing, lower unit as
you come across collar and continue straight across green until reaching other collar and raise as you come off
of green. Overlap stripes the same as if you were mowing.