Smithco Sweep Star 48H Operator Manual (2013) - Manual (Page 15)

13
English
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
OPERATION
Beater reel MUST BE DISENGAGED before starting engine.
SWEEP STAR 60 ACCELERATOR/REVERSE PEDAL
On the right floorboard of the Sweep Star 60 is a "rocker" pedal.
Push down on the front (G) with your foot and the machine will
accelerate. Push down on the rear of the pedal (H) with the heel of
your foot and the machine will go in reverse. The machine is in
neutral when foot is off the pedal.
SWEEP STAR 48H ACCELERATOR/REVERSE PEDAL
On the right floorboard of the Sweep Star 48H is the accelerator
pedal (J) and the reverse pedal (K). The machine is in neutral when foot is
off the pedal.
DAILY CHECKLIST
1. Check park brake adjustment. Adjust as required.
2. Check engine oil level. Add as needed. DO NOT OVERFILL.
3. Tire pressure should be 20 psi (1.4 bar) on all Sweep Star 48 tires and castor wheels. Tire pressure should
be 20 psi (1.4 bar) on Sweep Star 60 front tire and castor wheel, 18 psi (1.3 bar) on rear tires.
4. Inspect electrical system for loose connections or frayed wiring, including battery cables. Replace any
faulty equipment or tighten if loose.
5. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
6. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
7. Check hydraulic oil level in right side tank. The level should be 2" to 2 1 /
2
" (5-6.4 cm) from top of tank when
fluid is cold. If level is low, add SAE 10W-40 API Service SJ or higher motor oil.
8. Inspect steering, throttle and shift linkages for good hookups and clear travel.
9. Check controls for smooth, proper working operation. Lubricate as needed.
10. Check and clean all debris from engine compartment.