SOLAC CVG9900 - Manual (Page 12)

12 MAIN COMPONENTS AND ACCESSORIES
and have it disposed of according to current national legislation. Ask your
Distributor, Town Council or Local Authority for detailed information.
MAIN COMPONENTS AND ACCESSORIES
BEFORE STARTING TO IRON
i
Make sure you have removed the soleplate protector before starting to iron.
1 With your CVG unplugged, open the filler cap turning it upwards (fig 1).
i
Due to the high level of water hardness in most areas, Solac recommends that you
always use distilled or demineralised water for ironing. You will thus guarantee that
your CVG stays in perfect condition for as long as possible. If you cannot find distilled
water for any reason, be sure to use water that is low in minerals (soft).
i
Do not put any type of scale remover solvents or products in the water tank. Do
not use perfumed or ironing water either. These products can damage the
interior of the steam generation system.
2 Fill the tank without exceeding the maximum level using the beaker provided (8) and
keeping the CVG upright. After the tank is full, close the cap (1).
‹
Keep the water-filling hole lid (1) closed during operation.
3 Check the garment to be ironed to see if it has a label that indicates the ironing
temperature.
Z
We recommend that you classify garments by their required ironing temperature and
that you begin ironing with the garments that require the lowest temperature ( • ).
i
NB: Ironing delicate garments with a temperature higher than necessary is harmful for
the fabric and causes burnt residue to get stuck to the soleplate.
i
If you have any doubts about the temperature to use for a given garment, perform a
test on a part which won’t be seen, beginning with the lowest temperature settings.
1 Water filler hole cap
2 Water tank
3 Touchscreen
4 Handle
5 Temperature selector
6 Steam selector
7 Non-slip legs
8 Beaker
a Luminous icons
Position (MAX)
Position (•••)
Position (••)
Position (• ECO)
Ironing without steam
Medium steam 35 g/min
Maximum steam 60 g/min
Lock screen
SILK, WOOL, SYNTHETIC FIBRES, minimum temperature (•)
POLYESTER, medium temperature (••)
COTTON, max. temperature (•••)
LINEN, maximum temperature (MAX)
BOOKCVG9900.book Page 12 Friday, April 16, 2010 1:59 PM
Woolmark: The wool cycle of this iron has been approved by The Woolmark
for the ironing of pure wool products provided that the products are
to the instructions on the garment label and those issued by
this iron.