SOLAC CVG9900 - Manual (Page 15)

OTHER FUNCTIONS 15
en
VERTICAL IRONING
It enables you to remove creases from delicate garments without having to lay them on the
ironing board: jackets, coats, curtains, suede garments, etc.
1 Place the garment on a hanger, away from other garments, persons…
2 Select the desired ironing temperature, pressing the temperature selector (5) as many
times as necessary. Stand the CVG upright.
3 Press the steam selector (6) once or twice, defending on the flow of steam desired
(medium or maximum ).
i
At Position (••) you will obtain a more humid visible steam which will be easier to see,
whereas at Position (•••) and (MAX) the steam is drier and, although the same flow is
maintained, will be less visible.
FILLING WITH WATER
If while ironing the tank runs out of water, the CVG will emit different light signals depending
on the steam selector activated at the time:
• Steam selector deactivated: , , flicker
• Medium steam selector activated: lit up continuously and , flicker
• Maximum steam selector activated: lit up continuously and , flicker
1 Switch off the CVG, keep it upright and fill the tank using the beaker (8) provided.
Z
Dry the CVG with a dry cloth if any of the water spills out of the tank.
Z
If the appliance were to run out of water completely with the steam selector activated,
you would hear a strange noise from the micro-pump. Switch off the steam selector to
prevent any damage to the system.
Switch off the appliance and fill the water tank. When switching it on again, this noise
will disappear.
OTHER FUNCTIONS
ANTICALC SYSTEM
The CVG is fitted with an innovative anticalc system consisting of a resin filter, which retains
the limy substances in the water, preventing these from reaching the steam chamber in the
soleplate and thereby extending the life of your CVG. The existence of this anticalc system
does not mean you can ignore the advice on water hardness mentioned in the “BEFORE
STARTING TO IRON” section.
CLEANING AND CONSERVATION
SOLE-PLATE
1 Unplug the iron and let it cool down.
i
Use environment-friendly clay-based products to clean the sole-plate.
OUTSIDE
1 To clean the outside of your CVG, use a cloth moistened in soapy water.
i
Do not clean with abrasive chemical products or solvents as it may attack certain plastic
parts and / or remove some of the marks and / or indications.
2 Store your CVG in the vertical position, wind the cord round the heel and secure it with
the clip.
i
Although the power cord is fitted with a 360º rotational elbow, NEVER FORCE
this cord when winding it around the appliance on the first turn.
BOOKCVG9900.book Page 15 Friday, April 16, 2010 1:59 PM