SoundFreaq SFQ-04 - Manual (Page 11)

.10.
 The indicator on front panel starts blinking
quickly to indicate that the unit and your
device have entered into the connection
mode.
 After a Bluetooth connection is established
successfully, the indicator will be solid on.
6. Select the desired music and press "Play"
button on your device. The unit automatically
starts playing back the music.
 Ensure that the audio cable has been removed
from the AUX jack of Sound Kick when you do
not use App.
 Try again above steps 3 to 5 if the pair
indicator turns solid after blinking for 3
minutes, the pair was unsuccessful.
Using Multiple Bluetooth Devices
Only one device can be used at a time, but you
can switch between different Bluetooth devices.
Make sure each device you want to use has
already been paired, to switch devices:
1. On Sound Kick, press the pair button.
2.
On Bluetooth device, select the connection to
Sound Kick.
This device is now the connected device to Sound
Kick, (the previous connected device is now
disconnected). Repeat those steps to switch the
connected device again.
Note: If the unit has no sound output, please
check if the volume level of your Bluetooth
device connected to the unit is set to the minimum,
or the Bluetooth device is muted.
Playing back from Macbook or Macbook
Pro
1. In the desktop screen, Select the “Open
Bluetooth Preference”.
2. If there is any old “Sound Kick” records, remove
them. Click the “Continue” button to proceed
pairing process.
3. Once completed, the pairing success screen
will come out.
Note: Don’t quit the page immediately. You
may notice that the previous dialog screen
still shows the device not connected. Just
ignore it. It’s confusing to the user. In fact,
it’s connected already.
4. Open iTune, play a song. Then use the mouse
to click the Bluetooth icon at the top right
hand corner of the desktop screen, select
the “Sound Kick” option and then select the
“Use as Audio Device (Stereo)”. After a while (a
few seconds), the music will come out from
the SFQ-04. If not, select the “Use as Audio
Device (Stereo)” once again. The Sound Quality
should be good.
Playing back from PC/Notebook
1. Press the “Start” button to open the “Device
and Printers” dialog box.
2. Turn on the SFQ-04 system and press the
PAIR button on the unit to put the unit into
the pair mode.
3. Select the “Add a device” in the “Device and
Printer” dialog box. The “Sound Kick” icon
will appear on the display.
4. Double click the “Sound Kick” icon and wait
until the device has been added successfully.
5. Click the “Close” button to close the “Device
and Printer” dialog box. A ”Sound Kick” icon
appears in the dialog box.
6. Double click the “Sound Kick” icon and the
device connection screen will be shown.
7. Click the “Connect” button in the “Music and
Audio” option.
8. Once connected, the pair indicator on the
unit will be solid on and the connection
success screen will be shown.