Stührling AD101-1 - Manual (Page 3)

2 7 . 0 6 . 2 0 0 4 M o d e l : A D 1 0 1 - 1 P a g e : 3/4 E d i t i o n : 3
SWISSEBAUCHES
4. CHRONOGRAPH
¾ Turn S2 upwards to enter the Chronograph Mode from Alarm
Mode
¾ Press S1 to start Chronograph
¾ Press S1 to stop the timing and show the Add data or press S3 to
show Split data
¾ When the timing stop, press S3 to reset to zero
Remark:
1) The Maximum range: 99 days 23 hrs 59 min. and 59 sec.
(Resolution: 1/100 sec. for the first 24 hrs or 1 sec. for the rest)
2) Add and Split function supported
5. COUNT-DOWN TIMER
¾ Turn S2 upwards to enter the Timer Mode from Chronograph
Mode
¾ Press and hold S1 for 3 seconds to enter the setting mode and the
setting procedure is shown as follows:
Remark:
1) Press S1 to start or stop and press S3 to reset to preset value
when the timer stop
2) During setting, press S3 to show “No Function”
3) The Maximum range: 99 days 23 hrs 59 min. and 59 sec.
4) Beep sound will be released for 60 seconds at 0 and press any
key to stop it
6. PERMANENT DATE
¾ Turn S2 upwards to enter the Permanent Date Mode from Timer
Mode.
¾ Press S1 to turn on or off the display.
Remark:
1) The date cannot be adjusted in this mode which shall be
changed in Calendar Mode
2) Press S3 it will show “No Function”
7. END OF LIFE indicated
¾ When the voltage of the battery is below 1.4V, Permanent Date
Mode will appear the EOL character to indicate End Of Life, and
in other modes numerical display will blink.
General Feature:
Whatever mode the display is, it will automatically change to
corresponding mode when the Timer, Alarm or Alarm Agenda release
the alarm.
S2 S1
S3
S3 S1
S1
SPLIT
RESET
START CHRONOGRAPH
ADD (STOP)
DAY HOUR MINUTE
S2 (adjust) S2 (adjust) S2 (adjust)
S3 S3
S3
SECOND
S2 (adjust)
S3