Sundance SMT9650 - Manual (Page 8)

Document No.
S M T 9 6 5 0 U s e r G u i d e
Revision
3 . 0
Date
2 9 D e c 2 0 0 6
Page
8 of 36
6 DEMONSTRATION 1
This demonstration shows how a simple DSP application generated using PARS can be combined with a
front-end developed under Labview. TIt can be found in the
\Demos\Demo1\
sub-folder of the SMT9650
installation folder; this will be
C:\SundanceDSP\SMT9650\Demos\Demo1\
by default.
The hardware needed for this demonstration is pictured below.
There are two Sundance TIMs mounted on an SMT310Q carrier board: an SMT374 dual C6713 DSP
module (root & node) and an SMT364 4-channel ADC module. Data are carried between these modules
over comports and SDBs. The comport connections are built into the carrier, and an SMT596 SHB
connector is used to join the SDBs of the two modules.
The logical connections are shown in the following diagram:
SMT310Q
SMT364 SMT374
root node ADC
Host PC
3
4 1 1
0
comport connection
SDB connection
4