Super Systems AC20 Quick Start - Manual (Page 4)

Super Systems Inc. 4 1 (800)-666-4330
Cincinnati, OH 45241 Fax: (513) 772-0060
//Ssio1/main/.ssimanuals/ac20qs www.supersystems.com
To Change Process Setpoint:
When the device is in AUTO Mode and in Normal Display Mode
q Press the
⇑⇑
or
⇓⇓
for more than 2 seconds, and the set point will begin changing.
q After achieving the desired set point, the instrument will time out for 2 seconds, and
flash the new setting, indicating it has accepted the change.
To Change to CO Factor (When Instrument is in Carbon Control Mode):
When the device is in AUTO MODE and in Normal Display Mode
q Press the MENU button – (Gr. 1 will be displayed in Yellow)
q Press FUNC Button twice - This will display COF in the bottom window and the
value in the middle window (Set Point Window)
q Adjust the parameter by using
⇑⇑
or
⇓⇓
key
q After achieving the desired value, you must press the FUNC button once again for
the change to be accepted.
q The instrument will time out for 30 seconds and return to Normal Display Mode or
you may press the MENU button several times until you return to Normal Display
Mode
q To Verify that your change was accepted you may view the COF by pressing the
FUNC button until you reach COF in the lower Display.
To Change to H
2
F Factor (When Instrument is in Dewpoint Control Mode):
When the device is in AUTO MODE and in Normal Display Mode
q Press the MENU button – (Gr. 1 will be displayed in Yellow)
q Press FUNC Button three times - This will display H
2
F in the bottom window and the
value in the middle window (Set Point Window)
q Adjust the parameter by using
⇑⇑
or
⇓⇓
key
q After achieving the desired value, you must press the FUNC button once again for
the change to be accepted.
q The instrument will time out for 30 seconds and return to Normal Display Mode or
you may press the MENU button several times until you return to Normal Display
Mode
SSi
AC20 Quick Start Instructions