SVS 7HSE 110V - Manual (Page 11)

4. Hold relays on to raise/lower the Lift.
5. Never leave voltage on the up and down. Always program a release after the travel time has been
achieved.
If you have any questions please contact SVS for proper wiring.
9. ACCESSORY INSTALLATION
Please refer to the accessory installation instructions located in the accessory shipping crates for specific
instructions for each accessory. The Accessory #2 Plenum Shroud and Accessory #12 Decorative Cover require
that hardware be added to the threaded rods supporting the Lift before the Lift is installed. The Accessory #1
Ceiling Closure and FP1 Closure Panel attach the ceiling closure support brackets on the platform of the Lift
using supplied threaded rods.
10. MOUNTING THE PROJECTOR
After checking the Lift operation and all clearances you can install the projector on the Lift. The projector is
placed on the Accessory #13 Metal Platform (non-inverted). For custom mounting option please contact SVS.
All weight placed on the Lift must be centered between the lift's cables. The balance point of the projector
should be placed in line with the lift cables (+/- 1-inch). If this is not possible you may need to counter weight
the lift.
Leveling the Projector
• If you can not level the projector using the projector's leveling adjustments, you can adjust the level of
the lift.
• Level corrections are made with the projector mounted after confirming that the cable is packed tightly
and is straight on the Cable Drum.
• It is best to lower the lift to the Service position and then completely up before leveling the projector.
• Level adjustments should be made with the projector in the Show position.
• Position a level across the front of the projector. Fine adjustments are done by adjusting the nuts on the
bottom of the cable eye bolts. Raise and lower the Lift until satisfactory level is achieved.
• After adjustments are made tighten the eye bolt nuts.
11. CABLE MANAGEMENT
The SVS 7HSE Cable Retractor is a spring-loaded reel on the rear of the Lift. The Cable Retractor is used to
keep the projector cables away from the scissors during Lift operation. The retractor automatically retracts your
cable as the Lift ascends and releases your cable as the Lift descends.
Instructions:
1. Please read all instructions before installing your cable on the Cable Retractor.
2. Lower the Lift to its maximum down position (Service position).
3. Clamp your cable securely to the outrigger on the top frame of the Lift.
4. Wind the cable reel clockwise:
 2 ¾ complete turns for the SVS 7HSE-9
 3 ¼ complete turns for the SVS 7HSE-11
 4 complete turns for the SVS 7HSE-13
 4 ½ complete turns for the SVS 7HSE-15
SVS 7HSE Lift Installation Instructions Page 11 of 16