SVS 7HSE 110V User Manual

Page 12

Advertising
background image

Figure 10

 5 ¼ complete turns for the SVS 7HSE-18
 6 complete turns for the SVS 7HSE-20
 6 ½ complete turns for the SVS 7HSE-22

Warning: Over-winding the reel or winding the reel counter-clockwise will damage the

cable reel springs. Broken cable reel springs are not be cover by the Lifts warranty.

5. Hold the cable reel in this position to stop the reel from unwinding.
6. Attach upper half of your cable to the cable reel between two of the four (4) holes with 3/16” tie-wraps.

Leave the tie-wraps semi-loose in case adjustment is needed.

7. Make one and a half turns around the cable reel counter clockwise with your cable. Lock your cable in

the same way as the previous step, to the two remaining holes (180

°

from the first two holes used.)

8. Clamp your cable securely to the outrigger on the bottom frame of the Lift.
9. Run the Lift up and down to check the slack in your cable. Your cable will be slacked at the top of the

Lift when the Lift is in a full up position, and equally slacked at the bottom in a full down position.

Note: The Cable Retractor is located near the center of the scissors, but due to different number of scissors and
the opening time of the scissors, there can be slack in your cable above or below the cable reel as the Lift
lowers. Excess slack can be removed by adjusting the cable clamping on the cable reel after tracking the Lift up
& down. If the slack is adjusted correctly, the cable will be more even when in the up and down positions, with
slack occurring only in the middle position.

10. When proper cable tension is achieved, you can securely tighten the tie-wraps.

12. SETTING THE SHOW POSITION

The Show position is adjusted by positioning the Show position microswitch located on the rear right of the
Lift's top frame so that the large roller washer compresses the Show position switch when the Lift reaches the
Show position.

1. Place the key switch in the Service position and lower the Lift to the desired Show Position.

SVS 7HSE Lift Installation Instructions

Page 12 of 16

Advertising
This manual is related to the following products: