Teac SR-LUXi - Manual (Page 5)

5
Before Use (1)
CAUTION
< When moving the unit, always lift it by the sides
with both hands.
Correct way to lift
Incorrect way to lift
A light is on the bottom of the
top side.
Do not pick the unit up as shown
in this illustration because this
could cause damage.
< The voltage supplied to the unit should match
the voltage printed on the supplied AC adapter.
If you are in any doubt regarding this matter,
consult an electrician.
< Do not open the cabinet as this might result in
damage to the circuitry or electrical shock. If a
foreign object should get into the unit, contact
your dealer or service company.
< When removing the power plug from the wall
outlet, always pull directly on the plug. Never
yank on the cord.
Placement of the unit
< Choose the installation location of your unit
carefully. Avoid placing it in direct sunlight or
close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold
or moisture.
< As the unit may become warm during operation,
always leave sufficient space around the unit for
ventilation.
Make sure there is at least 8” (20 cm) of space
above and at least 2” (5 cm) of space on each side
of the unit. Do not place anything on top of the
unit.
< Do not place the unit on an amplifier or receiver
or any other device that generates heat.
< When the unit is turned on, switching on the
TV may cause lines to appear on the TV screen,
depending on the wave frequency of the TV
broadcast. This is not a malfunction in the unit
or the TV. If you see such lines, place this unit far
away from the TV set.
Maintenance
If the surface of the unit gets dirty, wipe it with
a soft cloth or use diluted mild liquid soap.
Allow the surface of the unit to dry completely
before using.
For safety, disconnect the power cord from
the socket before cleaning.
< Never spray liquid directly on this unit.