Teac HS-2000 - Manual (Page 125)

TASCAM HS-2000
125
12 – Mark and locate functions
Editing mark names
1. Select the mark that you want to edit on the
MARK
LIST screen.
2. Touch the
EDIT NAME
button to open the
MARK
NAME
screen.
Follow the procedures in “Editing project names” on
page 40.
If you want to edit the name of a BWF-J cue point,
touch the
BC$
button at the top right to open a cue
name pull-down menu where you can select the
desired type.
NOTE
You can also open the
MARK NAME
screen by touching
the mark name area on the Home Screen.
Since the names of automatic marks cannot be edited, the
MARK NAME
screen will not open for them.
Manual locate function
You can directly input a time to locate to it.
Touch the Manual Locate button on the Home Screen to
open the MANUAL LOCATE screen.
Touch the
FRAME EDIT
button to set whether or not
the frame value is editable.
Frame editing on
Frame editing off
There are three locate modes as follows.
ABS: Input an actual time and locate to it.
+ : Input the amount of time to go forward from the
current time.
– : Input the amount of time to go backward from the
current time.
Input the time using the number buttons.
You can also select a unit in the LOCATE area and use the
DATA dial to adjust the time.
Touch the LOCATE button to locate to that new time and
return to the Home Screen.
Touch the
CLEAR
button to clear all input values.
Touch the
CLEAR
button to reset all values to 00.
NOTE
If the CURRENT time display is set to T/C, the timecode is
used as reference for locating times .
TIP
This can also be edited using an external keyboard.
Press its Enter key to confirm a setting and its ESC key to
reset all values to 00.