Teac GRANDIOSO D1 - Manual (Page 12)

12 12
Basic operation
1
Press the POWER button to turn the unit on.
Press the POWER button in completely until it stops.
When on, the POWER button lights blue.
2
Press the INPUT selection button to select the
source.
Each time you press the INPUT selection button, the active input
changes in the following order and is shown on the display.
ESLINK XLR RCA1 RCA2
i.LINK USB OPT
Select the input and start playback from the audio source device.
If no digital signal is detected, no sampling frequency will be
shown to the right of the word “INPUT” on the display. Confirm
the connections before turning connected devices on.
o When you are done using this unit, press the POWER button
to turn it off.
o If the CH setting is set to Rch and an L-R LINK connection has
been made with an Lch unit, the input cannot be changed
from the Rch unit. Change the input using the D1 set to Lch.
1
Press the MENU button repeatedly to select the
desired setting item.
Each time you press the MENU button, the item shown on the
display changes.
UPCONV>
x
DSD_F>
x
CLK>
x
CLKin>
x
CLK_TH>
APS>
2
DPaOFF>
2
AOUT>
2
DIMMER>
2
CH>
If you press the INPUT selection button or do nothing for 10 or
more seconds, setting mode will end and ordinary mode will
resume.
If the CH setting is set to Rch and L-R LINK connections have
been made with a unit set to Lch, the only settings that can be
changed in setting mode are CLK, CLKin and CH. The other set-
tings will reflect changes made using the Lch D1.
2
Use the parameter adjustment (−/+) buttons to
change the settings.
For information about settings, see pages 13–16.
If you press the INPUT selection button once or do nothing for
10 or more seconds, setting mode will end and ordinary mode
will resume.
o Settings are retained even if the power plug is disconnected.
Setting mode