Thermo Technologies SBB Solar Storage Tank User Manual
Page 5
Installation instructions for the Installer
5. General
The illustration on page 5 is referenced for explanation of the following text.
5.1 Brief Description of the Appliance
5.1.1 Application
The Stiebel Eltron Vertical Solar Storage tank SBB … K SOL is, in combination with Stiebel Eltron’s Solar Collector is an
economical hot water generator.
5.1.2 Connectors
All connectors (cold and hot water connectors) are readily accessible and allow for easy installation.
5.2 Delivery Form
The hot water storage tank SBB … K SOL, wrapped in plastic wrap, is delivered on a one-way pallet. The storage tank
has foam insulation, a KU outer casing and KU cover.
Equipment
•
Storage unit with two welded steel plain-ended pipe heat exchangers
•
Hot water corrosion protection with special enamel coating
•
Maximum operation pressure
Hot water 145 PSI (10 bar)
Heated water 145 PSI (10 bar)
•
Three immersion sleeves for housing of temperature probe/thermometer
•
Magnesium Safety Anode
•
Circulation Socket G_A
•
Plug for bushing G1_
•
Attached Flange
•
PU Foam insulation 2.95 in. (70 mm.) thick
•
KU outer casing with zipper in protective pouch
•
KU Cover and Flange cover
Only for 600:
•
Removable PU-side panels with fastening strap and locking parts
5.3 Tasks to be performed by the Technician
An approved technician should perform the setup, installation and initial start-up following these instructions.
5.4 Regulations and Standards
Refer to: Local Construction regulations, fire-code and trade control regulations.
Solar Tank SBB 600 plus
with insulation
1 Solar tank
2 PU side panel
3 Fastening strap
4 Locking part
Diag. 3
3