Thermo Technologies SBB Solar Storage Tank - Manual (Page 8)

Diag. 5
6.5 Hot water temperature probe
6.5.1 The hot water temperature probe is to be installed into the immersions sleeve (Pos. 3 Diag.1) of the hot water
storage tank.
Then the connector pipe for heater regulation has to be installed and attached to the clamps of the low voltage plug as
described in separate operation and installation instructions for the regulator.
6.6 Solar Storage Tank – Temperature Probe
The solar storage tank temperature probe must be attached to the immersion sleeve of the hot water storage tank (Pos. 6
Diag. 1).
The temperature probe must be inserted into the probe sleeve until its dead stop (Ill.6). The compressed flat rod has to
be inserted until set with the spring struts in the front.
Then the connector pipe has to be laid according to solar regulator SOM 6K, SOM 6/3D or SOM 7/2 and attached to the
clamps of the low voltage plug as described in separate operation and installation instructions of the regulator.
Diag. 6 Diag. 7
6.7 Connection to the Solar Unit
The installation of the solar circuitry is shown in Diag. 5, page 12. The solar circuitry installation can follow the installation
diagram. This differs depending on the application.
Refer to the separate operation and installation instructions for the solar collector SOL 25 S .
Test operation after installation. Start up must follow the approval of the installer (refer operation and use).
6.8 Signal anode (spare part)
If a signal anode is installed into the SBB … K SOL storage tank, the following installation of the signal anode must be
observed:
Installation – signal anode
•
Pull out the red shut-off plug while simultaneously depressing the pressure ring, Diag. 6a. on page 13.
• Push in the open pipe end of the indicator element until dead-stop, Diag. 6b.
• Attach the sticker “Note Signal Anode” to a highly visible spot on the insulation.
When the storage tank is not operated with a signal display, the red plug must remain in the anode!
Function – Signal Anode
(Safety Anode with usage display)
• After consumption of the anode, humidity escapes through the hollow anode core to the signal cartridge and causes a
color change there (refer Diag. 7)
• When the cartridge turns red contact the installer so he can check the anode and if needed replace it.