Tri Tool CBM-3 Counterbore Module - Manual (Page 12)

12
TRI TOOL INC.
92-0227 : Rev. 070529
NOTE:
To feed the Tool Bit in, hold the Feed Knob.
Do not use a wrench or lever to obtain extra holding strength.
Do not force the feed, if the feed pressure builds up too high, release the Knob for 2
or 3 revolutions.
The feed rate is .010” (.25 mm) per revolution, if the Feed Knob is held con-
tinuously.
For a lighter feed rate, hold and release the Feed Knob as the Clamshell revolves.