Wavecom W-Sat-email-Decoder V2.3.1 - Manual (Page 19)

WAVECOM Sat email Decoder W-Sat-email-Decoder V2.3.1 Reference  15
Reference
Input data format
The Decoders now support two formats:
 Data stream extracted from INMARSA-B, INMARSA-M or INMARSAT-mM frames
 Raw data from Inmarsat-B-HSD (ISDN)
INMARSAT-B, INMARSAT-M or INMARSAT-mM
Use this format for INMARSAT-B, INMARSAT-M or INMARSAT-mM low speed data. The expected format is
the data extracted from the HDLC I-Frames in the correct order and without duplicates. In other words,
the same data stream a user of the satellite services sends and receives.
INMARSAT-B-HSD
Use this for ISDN data (SAT-B-HSD). The format consists of the raw contents of the data frames, without
signaling units.
Metadata output format
The metadata output is not yet fixed. The following format description is based on the XML output by the
GUI. For now, not all decoders are able to write metadata.
The XML files created by the GUI are structured as follows:
<MetaData>
<Transmission>
<!-- This part is filled by the GUI. Decoders do not use it. -->
</Transmission>
<Mail>
<!-- Generic mail information by the decoder. There may be several mails in one file. -->
<Attachment>
<!-- Attachment data. There may be several attachments in one mail. -->
</Attachment>
</Mail>
</MetaData>
Transmission section
The “Transmission” part is only written by the GUI. It is omitted when the DLL is used directly.
Tag name (key) Value
MES_ID MES ID of the sender
Mode Transmission mode
Mail section
This part contains information about mails.