ZeeVee ZyPer4K (10G-IP) - Manual (Page 4)

Page 4
|
ZyPer4K Configuration Guide www.zeevee.com
Front and Back Panels
F R O N T P A N E L S
A RS-232 – Port used to connect to and control
peripherals (STB, Blu-ray, projector)
B P1 – Not used currently
C P2 – Pushes EDID information from connected
display to all connected Encoders. Resets to
the factory default settings. Press button for 10
seconds while powering up to revert back to
default factory settings.
D Pwr – Indicates when power is turned on
E Vid – Indicates when video is present in the unit
F IR-in – Infrared receiver-in port used to receive IR
signals (for example, from a user with a remote
control)
G IR-out – Infrared receiver-out port used to connect
to and control peripherals
H AUDIO – Audio connector for analog audio use
B A C K P A N E L S
I POWER – 5V DC power input port
J HDMI IN – (Encoder only) Indicates HDMI-in cable
port
K HDMI OUT – (Decoder only) Indicates HDMI-out
cable port
L TX – Flashes when system is operating and data is
being transmitted across fiber link
M RX – Flashes when system is operating and data is
being received across fiber link
N Media/10Gb Ethernet – Slot for SFP+ Fiber Optic
Module (available from ZeeVee)
O Utility/1Gb Ethernet – Network port for
connection of local Ethernet device into network
FRONT PANEL — ENCODER AND DECODER
BACK PANEL — ENCODER
A B C D E F G H
BACK PANEL — DECODER
I L M N O K J