ZeeVee ZyPer4K (10G-IP) - Manual (Page 8)

Page 8
|
ZyPer4K Configuration Guide www.zeevee.com
Connecting Encoders to the 10Gb Network Switch
1. Connect HDMI cable from active source to Encoder (HDMI In port). Ensure Encoder is plugged in and pwr
LED light is illuminated. When HDMI cable is connected, the video (vid) light will illuminate.
2. Insert SFP+ module into the 10Gb Optical Ethernet port on the Encoder. You should hear a click sound
when it is correctly inserted.
3. Insert fiber optic cable into the SFP+ module. Again, you should hear a click sound when correctly inserted.
4. Connect fiber optic cable from the Encoder into any available 10Gb fiber port on your 10Gb switch (IGMP
compatible). Ensure port has SFP+ module. You should hear a click sound when correctly inserted and the
activity link light on the 10Gb switch will blink. Encoder icon now appears in management software.
5. Right click on Encoder icon and choose Settings to configure Encoder options. Please refer to Configuring
Encoder/Decoder Options on page 10 for more detail.
6. Add additional Encoders using the steps above. Note: it does not matter what order you connect Encoders
or Decoders. For the purpose of this documentation, Encoder connection is presented first.
Name of device
Current IP address
assigned to device
Firmware version details
Multi-cast address
(or channel #) for
the video on device
Video resolution
of the device