AEC Colortronic MTF 3000 Series Granulator - Manual (Page 13)

4.0 Electrical System Notes
4.1 Start-Up or Operation Problems
Granulator will not start:
Check all fuses. If blown, try to locate grounds or other reasons. Replace fuses with the size
and type shown on the wiring diagram (located in the control enclosure).
Check granulator motor and fan overloads. If required, reset #1 MOL, #2MOL.
Check for an open safety limit switch at the machine front doors or at any limit switch
protected hopper cleanout door.
If not equipped with a fan, check the jumper on terminals #3 and #5.
Call the Colortronic Service Department for assistance if the machine still will not start.
Have the machine serial number and/or W/Q number at hand (located on the serial number
plate on the cutting chamber).
Fan motor will not start (optional):
Check fuses #1, #2, and #3. If blown, try to locate grounds or other reasons. Replace fuses
with the size and type shown on the wiring diagram (located in the control enclosure).
13