AEC Colortronic MTF 3000 Series Granulator - Manual (Page 21)

3. If you find a “high” rotor knife, mark it and re-adjust to this knife.
4. Once knife adjustments are completed, equally and fully torque the bed knife socket cap
screws, working from the center out toward the ends of the knife. Refer to Section 10 for
the correct torque values based upon bolt sizes and thread pitch.
5. Recheck the clearance once the bolts have been fully torqued and reset if necessary.
6. Turn the rotor so that the knives are aligned with a primary bed knife on the rear of the
granulator and continue with the same procedure used to setup the secondary bed knives.
7. After the clearance setting of both the secondary and primary bed knives is completed and
checked, turn the rotor by hand to ensure that none of the rotor knives hit the bed knives.
8. Re-install the screen into the screen chamber and close the machine (refer to section 10).
21