3 checking connection with the ap – Airlink RT211W User Manual
Page 18
54Mbps Wireless Access Point User Manual
12
3.3 Checking Connection with the AP
You can use the Ping command to verify whether or not your
Ethernet/Wireless client has successfully connected to the 54Mbps
Wireless Access Point.
To execute the ping command, open the DOS window and ping the
IP address of the AP at the DOS prompt. For example:
ping 192.168.1.1
If the following response occurs:
Reply from 192.168.1.1 bytes=32 time=100ms TTL=253
Then the connection between the 54Mbps Wireless Access Point
and the network has been successfully established.
Otherwise, if you get a failed ping with the response of:
Request time out
Then the connection is fail. Verify your network setting is correct.
For Ethernet client, also check the cable between the AP and the
PC.