Airmar G2183 GPS - Manual (Page 10)

10
2. Decide if you want the cable to exit through the center or along the side of the
pole/rail bracket. Slide the nut assembly onto the cable at the sensor
connector. Do not connect the sensor at this time.
a. Center exit—Pass the instrument connector end of the cable through the
center of the pole. Be sure to leave several inches of cable extending beyond
the nut assembly.
b. Side exit—Place the cable side-exit adaptor (part D) over the cable. Being
sure the cable is passing through the slot in the side, screw the nut assembly
onto the adaptor. Hand tighten only. Do not over tighten.
NOTE: Use the adaptor supplied as it has smooth edges that will not chafe the
cable. Do not use a purchased part.
3. Screw the extension pole/rail bracket onto the nut assembly /side-exit adaptor.
Hand tighten only. Do not over tighten.
4. Remove the protective cap from the sensor connector on the cable. (Save the
cap to protect the connector when the receiver is removed.) Plug the cable
firmly into the sensor.
5. With the alignment tab on the sensor facing forward, slide the captive nut
upward and screw it onto the mount base. Hand tighten only. Do not over
tighten.