Alinco DJ-175 - Manual (Page 47)

9.Cloning and Packet Operation
9
47
9. Cloning and Packet Operation
The memory data and customized operational parameters can be transferred from a
Master unit to other DJ-175 (Slave units).
9.1.1 Cable Connection
• Connect the speaker jacks of the setting sending transceiver and the receiving
transceiver using a 3.5 stereo mini plug cord as shown in the diagram.
• Be certain that both units are switched off before connecting them.
• After connecting the units, switch them both on.
9.1.2 Master/Slave Units
Press the PTT key three times while holding down
the MONI key.
"CLONE" is displayed on the LCD, and both units
enter the Clone mode.
NOTE:
This operation is required also to program the data using utility software.
Master
To SP jack on the transceiver
Slave
To SP jack on the transceiver
Cloning 9.1