Amer Networks SS2R48G4i V2 - Manual (Page 55)

SS2R24G4i/SS2R48G4i
44
5.2.4 Traceroute
Command traceroute {<ip-addr> | host <hostname> }[hops <hops>] [timeout <timeout> ]
Function This command is used to test the gateways passed by packets on their way from sending
equipment to destination equipment, in order to check whether the network can be reached and to
locate the fault of network.
Parameters <ip-addr> is the IP address of the destination host, in dotted-decimal format;
<hostname> is the host name of the remote host. <hops> is the max number of passed gateways
allowed by Traceroute. <timeout>is the timeout value of packets, in millisecond, ranging from 100 to
10000.
Default Setting The max number of passed gateways is set by default as 16, while the timeout value is
2000 milliseconds.
Command Mode Admin Mode.
Relative Command ip host
5.2.5 Show
show
command is used to display information about the system , port and protocol operation. This
part introduces the show command that displays system information, other show commands will be
discussed in other chapters.
5.2.5.1 show arp
Command show arp
Function
Display ARP Mapping table
Command Mode
Admin Mode
5.2.5.2 show clock
Command show clock
Function Display current system clock
Command Mode Admin Mode
Relative Command
clock set
5.2.5.3 show debugging
Command show debugging
Function Display the debugging state
Command Mode Admin Mode
Relative Command debug
5.2.5.4 show flash