Aqua Lung Dimension i3 / Lotus i3 BC - Manual (Page 11)

English
© 2012 Aqua Lung International
BC
Home
ATTACHING THE MP HOSE TO THE FIRST STAGE
1. Remove the inflator hose
from the power inflator body by
gripping the grooved sleeve over
the quick disconnect coupling
with your thumb and forefinger.
Slide the sleeve back.
2. Remove the port plug from an MP port on the regulator using
an appropriately sized wrench.
WARNING: DO NOT connect the inflator hose to a
high pressure (HP) port (greater than 200 psi / 14 bar).
This may cause the hose to burst when pressurized,
which can result in serious injury. If you are unsure
which regulator port is medium pressure (MP) or
high pressure (HP), consult your regulator owner’s
manual or your dealer before attaching the hose.
3. Check to ensure the o-ring is present and in good condition.
Screw the threaded end of the hose into the port and tighten to
40 in-lbs (4.5 Nm) with a 9/16” wrench.