Aquatic AV AQ-DM-5UBT - Manual (Page 4)

No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
Power Antenna (7)
Fuse Box
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
(White/strip)
The AQ-DM-5UBT includes the universal harness AQ-UNH-2 in order to connect the dock to
power and speakers.
All open wire connections should be soldered and protected against water and dust for best long
term performance.
1.3 12-pin Harness Connection
1. A mounting template is included. Aquatic
AV recommends using the ‘measure twice, cut
once’ method!
2. Once the mounting hole is complete, make
sure the outside surface is clean and clear of
debris. The Digital Media Locker has an exter-
nal water/dust proof gasket, but this requires
a clean and flat surface for best performance.
3. The Digital Media Locker has six (6) front
screws. Drive the screws using a screw driver.
During final mounting apply equal pressure to
all points for the best water/dust outer seal per-
formance. Make sure screws are snug and do
not over tighten.
4. Review all outside surfaces of the Digital
Media Locker to ensure proper water/dust seal.
This is important for long term environmental
protection performance for your digital media
device.
1.4 Mounting the Digital Media Locker
194mm
118mm
95mm 66.8mm
Getting Started
Digital Media Locker AQ-DM-5UBT
4 www.aquaticav.com