ARAG Digiwolf Tank filling system - Manual (Page 6)

6
3.1 Electric connections
The tank filling system must be connected using the supplied cables.
- Remove the protection cap from the valve
- Position seal (
1 in Fig. A) onto connector (2 in Fig. A), then connect the latter pressing it fully home
( 3 in Fig. A). During this operation, take special care not to bend valve electric contacts.
- Fasten screw ( 4 in Fig. A) until it is tightened.
CAUTION: If the gasket is not positioned correctly, there may be infiltrations of water
in the connector and in the valve, with the consequent risk of damage to the device.
DO NOT CONNECT THE POWER SUPPLY USING DIRECT FASTON CONNECTORS.
Bravo connector ( C) - Connections:
Cable colour Position Connection
Grey 1 GND
Brown 2 +12 VDC
Yellow/Green 3
Signal
(square wave)
Black 4 Pump control
Tab. 1
INSTALLATION
4
3
2
1
12 Vdc to flowmeter
valve cable
to computer
(e.g., Bravo 400s,
Bravo 300s)
1
2
3
4