ARM Electronics SDKBD2&3 - Manual (Page 7)

1 2 3 4 5 6 7 8 ON
PELCO-D/2400Bps
1 2 3 4 5 6 7 8 ON
PELCO-P/4800Bps
1 2 3 4 5 6 7 8 ON
PELCO-P/9600Bps
1 2 3 4 5 6 7 8 ON
COP-2/9600Bps
d) Switching control between speed dome and multiplexer： The controller can be operated in two
modes: Speed Dome and Multiplexer. When power supply is on it is operated on the default mode,
namely, the Speed Dome. Press [F3] to make switch between two modes. When it is under the mode of
the Multiplexer, you can control it via “Address Box”. At this time, the LCD will display “Mulx
Addr:001”. Alternatively you can control it by pressing [F3] down until the LCD displays
“CONTROLLING MULX”, then control the multiplexer by the RS-232 output of the keyboard. The
RS-485 output of the keyboard cannot be used to control the multiplexer. When operation, please pay
attention to the information on the LCD.
V. Operation of the Keyboard
1. Select Address of the Speed Dome Camera：[CAM]+[N]+[Enter]
Display: Current CamID：001
Description：N –– No. of camera from 0 to 255
Function：Select the address of the camera to be controlled. When the value N is in conformity with the
address of the Speed Dome Camera, it will be under control.
2. Set the Preset Position：[PRESET]+[N]+[ Enter]
Display：Preset No：001
Description：N –– No. of preset position from 1 to 128.
Function：Store current position and refer it as No. N position.
3. Call the Preset Position：[CALL]+[N]+[ Enter]
Display：Call Number：001
Description:：N –– No. of preset position from 1 to 128.
Function： Transfer the camera to the position of No. N preset position.
4. Cancel the Preset Position:[PRESET]+[N]+[OFF]
Display：Preset No：001
Description：N –– No. of preset position from 1 to 128.
Function：Delete the No. N preset position stored.
5. Set the Cruise Track (COP-2, PELCO-D, PELCO-P Available)：
z Enter the Status of Track Setting：[SHOT]+[N]+ [ON] (N：No. of track from 1 to 6).
Display：Track = 01 Sum = 06
Description：Track No.1 is currently setting, in which there are 6 preset points.
z Edit Track：Press [TELE] to edit down page and press [WIDE] to edit up page. Each track involves
16 preset points and the running speed and the dwelling time of each preset position.
Display：No.：01 Point：001 → Description：The 1st preset position in the track is 001.
Display：No.：01 Speed：001 → Description：The speed of the 1st preset point in the track is
the 1st class.
Display：No.：01 Time： 004 → Description：The dwelling time of the 1st preset point in the