ATL Telecom Berkshire SD14 - Manual (Page 4)

• Change the setting until the Message
Waiting lamp goes off with the
telephone plugged into the line.
• Check the operation of the Message
Waiting lamp by getting a colleague to
leave a message for you. If the lamp does
not work try another setting for the
selector switch or contact your telephone
supervisor.
ALL OPERATIONS SEEM SATISFACTORY
EXCEPT THE R BUTTON
•
Change the position of the dial selector
switch on the underside of the
telephone.
RING INDICATOR LAMP COMES ON BUT
NO TONE CALLER VOLUME
•
Check that the Tone Caller Volume
control has not been set to the OFF
position.
If none of the above resolves your problem,
please telephone ATL Telecom’s Technical
Support (029 20797610) who will be pleased
to assist you.
6. Compliance notes
The Berkshire SD14 may be connected to the
following types of installation:
1.
Direct Exchange Lines (DELs)
2. Compatible Private Automatic Branch
Exchanges (PABXs). Please contact the
supplier of your Berkshire SD14 to
confirm compatibility with your PABX.
Whilst the Berkshire SD14 is compliant as an
extension to compatible PABX and PMBX
systems, it cannot be guaranteed to operate
under all possible conditions of connection.
Any case of difficulty should be referred in the
first instance to the supplier of your
telephone.
The connecting plug at the end of the line
cord complies with the requirement of the
Telecommunications Network Voltage (TNV)
Guarantee
Your Berkshire SD14 telephone is designed
and manufactured to exacting quality
standards. This enables ATL Telecom Limited
to offer a full 10 year guarantee from the date
of purchase. This guarantee protects against
faulty material or workmanship, applies to the
UK only and is not transferable.
The terms and conditions under which the
guarantee will be valid are as set out below.
1.
Misuse or any modification carried out to
the telephone, or operation other than in
accordance with the instructions
supplied, will invalidate the guarantee
2. Damage arising from incorrect
installation, accidental damage or
consequential loss, are not covered under
the guarantee.
3. In the event of a fault developing during
the period of the Guarantee, the
complete telephone should be returned
to your supplier, adequately and safely
packed, together with proof of date of
purchase.
4. The liability of ATL Telecom Limited will
be limited to the cost of repair or
complete replacement of the defective
instrument, at the discretion of the
company.
5. The terms of this guarantee do not affect
your statutory rights.
Manufacturer’s Declaration
ATL Telecom Limited declares that this product
is in conformity with the essential
requirements of the ‘R&TTE directive
1999/5/EC’
Note: A copy of the Declaration of Conformity
is available upon request from ATL Telecom
Limited.
ATL Telecom Limited,
Cypress Drive,
St Mellons,
Cardiff, CF3 0EG
Telephone: (029) 20500700
Facsimile: (029) 20500701
1/310/001/610 Issue 03 May 2002