Eneo PNR-5108 - Manual (Page 16)

Quick Reference Guide
10
DVRNS
 Server Address, Server Port: Enter the IP address
(domain name) and port number of the DVRNS
server to register the NVR system.

Use DVRNS: Allows you to enter the name
instead of the IP address of the NVR system by
using the DVRNS function when connecting to
the NVR system.
− Use NAT: Check the box when the NVR system uses a NAT (Network Address Translation) device
for network connection.
− Name: Enter the NVR system name to be registered on the DVRNS server. Check whether or not the
name is available by clicking the Check button.
NOTES:
 The DVRNS (DVR Name Service) function allows the NVR system to use dynamic IP addresses for remote
connection. When using this function, you can access the NVR system remotely by using the NVR system
name instead of its IP address. For the DVRNS function to work properly, the NVR system should be
registered on the DVRNS server.
 When LAN settings are changed, set up the DVRNS settings after saving your LAN changes by clicking
the OK button.
 You will need to get the IP address or domain name of the DVRNS server from your network
administrator. You can use the domain name instead of IP address if you set up the DNS server during
the IP Address setup.
 When using a NAT (Network Address Translation) device, refer to the NAT manufacturer ’s instructions
for the proper network settings.
 The NVR system name you entered in the Name field should be checked by clicking the Check button,
otherwise the DVRNS changes will not be saved. When entering no name or a name already registered
on the DVRNS server, an error message displays.
Port
It allows you to change the port numbers of the
administration, recording and monitoring services
that are running in the NVR system.
SSL
 Use SSL: Allows you to enhance the security of
data transferred between services of the iNEX
program by using the SSL (Secure Sockets Layer)
protocol. Using the SSL function might cause
congestion in the NVR system depending on the
security level. Log in the iNEX program again
after you change the setting. When the setting is
changed, all services that are currently connected
to the administration service reconnect, and the
iNEX Setup and iNEX Client programs are logged
out.