H3C Technologies H3C S12500-X Series Switches - Manual (Page 5)

5
1. Align the CXP transceiver module (with the pull latch on top) at one
end of the AOC with the port in the chassis, as shown in
Figure 5 .
2. Horizontally and gently push in the module to fully seat it in the
port.
Figure 5 Installing a CXP AOC
To remove a CXP AOC:
1. Put your forefinger in the pull latch. Horizontally and gently pull
out the module.
Do not use excessive force to avoid pull latch damage.
2. Install the dust plug if no optical fiber is installed in the module.