H3C Technologies H3C S10500 Series Switches - Manual (Page 47)

37
Figure 39 Connecting the console port to the terminal
Setting terminal parameters
To access the device through the console port, you must run a terminal emulator program (HyperTerminal,
PuTTY, or Tera Term) on the configuration terminal. For information about using a terminal emulator
program, see the program's user guide.
The following are the required terminal settings:
• Baud rate—9600.
• Data bits—8.
• Stop bits—1.
• Parity—none.
• Flow control—none.
Powering on the switch
Before powering on the switch, confirm the following:
• You know where the emergency power-off switch for the equipment room is located.
• The switch has been securely mounted.
• All the cards have been correctly installed.
• The unused slots have been installed with filler panels.
• All the network cables, fibers, power cables, and grounding cables have been correctly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is correctly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
To power on the switch: