H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 23)

14
Figure 5 Wireless switch installation flow
Mounting the wireless switch on a
workbench
If a standard 19-inch rack is not available, you can place a WX3010E
wireless switch on a clean, flat workbench, as follows:
1. Check that the workbench is sturdy and well grounded.
2. Attach the four rubber feet to the recessed areas on the chassis bottom.
Install the wireless
switch
Install the wireless switch
to a 19-in rack
Mount the wireless
switch to a workbench
Ground the wireless
switch
Install a lightning protector
for a port (optional)
Connect Ethernet
cables
Connect the power
cord
Power on the wireless
switch
Normal?
Yes
End
No Power off the wireless
switch
Troubleshoot the
wireless switch
Start