H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 35)

26
Figure 16 Connecting an optical fiber
After powering on the wireless switch, check the SFP port status LED.
Table 9 Fiber port LED description
LED Status Description
1000Base-X
SFP port LED
(green)
Steady green The port is operating at 1000 Mbps.
Flashing green
The port is sending or receiving data
at 1000 Mbps.
Off No link is present.
Connecting the AC power cord
CAUTION:
•
Use a bail latch to secure the power cord to the wireless switch after
connecting the AC power cord.
• Before powering on the wireless switch, connect the grounding cable of
the wireless switch.
• Turn off the power source before connecting the power cord.
To connect the AC power cord: