H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 85
71
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the AC, which is chosen in this order:
•
The IP address specified with the nas-ip command on the AC
•
The IP address specified with the radius nas-ip command on the AC
•
The IP address of the outbound interface (the default)
Figure 23 Adding an access device
# Add a charging plan.
Click the Service tab, and select Accounting Manager > Charging Plans from the navigation tree to enter
the charging plan configuration page. Then, click Add to configure a charging plan as follows:
•
Add a plan named UserAcct
•
Select Flat rate as the charging template
•
Select time for Charge Based on, select Monthly for Billing Term, and type 120 in the Fixed Fee field
•
Type 120 in the Usage Threshold field and select hr for the in field to allow the user to access the
Internet for up to 120 hours per month
•
Leave the default settings for other parameters and click OK to finish the configuration.